Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
CD DISC PROGRAMMING (BY REMOTE CONTROL)
Up to 20 tacks can be programmed for CD file and play in any order. Before use, be sure the
system is at stop mode before programming:
1. Set in CD or USB mode & stop the playback.
2. Press the "PROG" button, "P01" and "PROG" will appear on LCD display. Moreover, it will
indicate program no. and digits for track no. to be programmed.
3. Select a desired track by pressing skip
4. Press the "PROG" button to store the trace into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press "PLAY/PAUSE" button to play the
disc in assigned order.
7. To cancel the programmed file, press "STOP" button on remote handset until "PROG" is
disappear on LCD display
The system is able to encode music to MP3 format and recording at memory media with USB
connecting port. The system will create a music folder name.
A)CD encoding
1. Insert a CD with the printed side facing up into the CD compartment and then close the CD
compartment
2. Press the "REC " button, the display will show "rEC".
3. The CD start playing and USB encoding.
4. The unit is separating each title.
5. After completing of encoding, unit will stop playback automatically.
I)Encoding by program
1. Place a CD with the printed side facing up inside the tray & then close the CD door
2. Select the desire tracks by following "CD disc programming" procedures. Then press "CD
PLAY/PAUSE" button to start playback.
3. During CD playback, press the "RECORD" button LCD display will flash "rEC" a while then the
display will appear "USB" and "ONE" are flashing. Encoding is performing now. After complete
encoding, unit will stop playback automatically.
Remark:
-
The recording speed is 1:1 and according to the actual plying time of the CD track
The recording format is preset at – MP3 bit rate: 128 kbps, sampling rate: 44.1khz
-
-
No song title will be recorded during encoding mode
To interrupt the recording, press the "STOP" button during record mode
-
II)Copying of MP3 file
If putting a MP3 disc instead of a CD-disc, the system will copy the files to the USB if press the
"Record" button. The operation procedures are the same as CD encoding as stipulate on above,
and the system will switch to copy mode only if MP3 file being read.
B)Phono/Cassette/BT encoding
1) Set the function button to "Phono/Cassette/BT" mode and then press the "Record" button
directly.
2) Now the system is starting the encoding mode. "USB" is flashing in the display
3) Start playback at phono or cassette for the track which you want to record to USB
4) After finish of recoding, press the "STOP" button until the LCD displays "END" and return to
"PHONO/CASSETTE" mode.
or
buttons.
ENCODING TO USB
8
NR560 / English Instruction Manual
Advertenties
Inhoudsopgave
