manually.
BEDSIDE SLEEPER FUNCTION
In order to use the bedside sleeper function, the product must be prepared
accordingly. To do this:
1.
Undo the zips on both sides of the opening side (fig. 8a).
2.
Slide the locks (A, fig. 12). Release the handrail connecting tube.
3.
Lower the side wall of the cot. Secure the handrail connecting tube with the
elastic bands located on both sides of the opening side.
4.
Align the cot with the caregivers bed and adjust the height of the cot so
that the caregiver's mattress is of equal height or a maximum of 2 cm higher
than the top of the opening side of the cot.
Note! The bottom of the cot in the bedside sleeper function must be parallel to
the ground. A difference in level between the sides of the cot is not permitted.
5.
Connect the installation straps to the cot by fastening the buckles (B, fig. 12).
6.
Wrap the installation straps around the mattress of the caregivers' bed and
then fasten the buckles (C, fig. 12).
7.
Adjust the length of the straps and make sure there is no gap between the
caregivers' bed and the cot (A, fig. 13).
NOTE: Before each use, check that there is no gap between the caregivers'
mattress and the side wall of the cot.
WARNING: Use of the product is only permitted with beds and/or mattresses
that have straight sides. The use of the product next to beds and/or round
mattresses and water mattresses is prohibited (B, fig. 13).
DISASSEMBLY INSTRUCTIONS
1.
Remove the mattress from the cot.
2.
Undo the zips in the cot's cover (fig. 15).
3.
Release and remove the handrail connecting tube (fig. 8b).
4.
Unfasten the hook and loop fasteners connecting the cover to the support
frame (fig. 6b), remove the stiffening element for the opening side (fig. 16)
and then remove the cover.
5.
Remove the support frame by pressing the release button (fig. 17).
6.
Remove the accessory basket by pressing the release button (fig. 18).
EN
‑ 12 ‑