Advertenties
Beschikbare talen
Beschikbare talen
A301_5(En)
03.4.24 7:45 PM
9
Before Calling for Service
The malfunctions shown in the left-hand column below, labelled "Fault," do not necessarily indicate functional
faults of the machine. It is therefore advisable to refer to "Checking" shown in the right-hand column before
calling for service.
(1)
The display shows symbols that do not make sense.
(2)
The display won't illuminate even when the mode switch
is turned to any other position than "
(3)
The display is illuminated, but the whole machine
refuses registrations.
(4)
No receipt is issued.
(5)
No journal paper is taken up.
(6)
Printing is unusual.
Error message table
When the following error messages are displayed, press the
table below.
Error message
ENTRY ERROR
MISOPERATION
NO RECORD
MEMORY FULL
SBTL COMPUL.
TEND COMPUL.
NOT ASSIGNED
OVER LIMIT.
INH. OPEN PR
INH. UNIT PR
NOT NON-TEND
BUFFER FULL
HEAD UP
PAPER EMPTY
CLERK ERR.
Downloaded from:
http://www.usersmanualguide.com/
Page 75
Fault
".
Error status
Registration error
Misoperation error
Undefined code is entered.
Memory is full (in the AUTO key programming). Program the AUTO key within 25 steps.
s
Compulsory depression of the
direct finalization
Compulsory tendering
No entry of a clerk code
Overflow limitation error
The open price entry is inhibited.
The preset price entry is inhibited.
The direct finalization is inhibited.
Subtotal void is not allowed.
Print head release lever is lifted up.
Receipt and/or journal paper roll is not
installed or empty.
CCD compulsory
Checking
• Has the machine been initialized properly as shown in
"GETTING STARTED"?
(Note that initialization clears all the data and programmed
settings stored in memory.)
• Is power supplied to the electrical outlet?
• Is the power cord plug out or loosely connected to the
AC outlet?
• Is a clerk code assigned to the register?
• Is the mode switch set properly at the "REG" position?
• Is the paper roll properly installed?
• Is there a paper jam?
• Is the receipt function in the "OFF" status?
• Is the print head release lever at the printing position?
• Is the take-up spool installed on the bearing properly?
• Is there a paper jam?
• Is the print head release lever at the printing position?
• Is the paper roll properly installed?
l
key and take a proper action according to the
Make a correct key entry.
Make a correct key entry.
Enter a correct code.
s
key for
Press the
key and continue the operation.
Make a tendering operation.
Make a clerk code entry.
Make a registration within a limit of entry.
Make a preset price entry.
Make an open price entry.
Make a tendering operation.
Finalize the transaction, and correct the wrong
mode.
entries in the
Move the lever toward the take-up spool (to the
printing position).
Install a receipt and/or journal paper.
Make CCD operation.
Action
75
Advertenties
