Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
and special 2-stroke engine oil in a mixing ratio
of 50:1, (50 parts petrol to 1 part 2- stroke engine
oil), Mix the fuel in the mixer bottle provided.
Shake the container gently and ensure thorough
mix.
Important: Do not use a different mixing ration
and do not use pure petrol, failure to use the
correct petrol/oil mixture will cause the engine to
seize.
Do not use fuel if it is more than 2-3 months old.
If you do not intend to use the machine for a
lengthy period, empty the tank and refill it before
you start work again.
Ensure that you do not overfill the tank and spill
petrol. (If you do spill, wipe up the excess amount
and wait until the vapors have evaporated –
danger of ignition.) Screw the tank cover back on.
7.5 Handle assambling
Assamble the handle (1) as shown in fig. 5
8. Operation
Check the fuel level and top it up if necessary.
•
Make sure that the generator has sufficient
•
ventilation.
Make sure that the ignition cable is secured to
•
the spark plug.
Inspect the immediate vicinity of the generator.
•
Disconnect any electrical equipment which may
•
already be connected to the generator.
8.1 Starting the engine (Fig 2)
Important: Do not use any chemical starting
agents such as highly volatile fuels or similar.
Open the stop cock (Item 3) by turning it down.
•
Move the ON/OFF switch (Item 7) to the "I"
•
8
position.
Pull the choke lever (Item 6).
•
Start the engine with the starter cord (Item 4) by
•
pulling the handle forcefully. If the engine does
not start, pull the handle again. Important:
Always pull the starter cable slowly until you
feel the initial resistance before you then pull
it quickly to start the engine. Do not allow the
starter cable to whip back of its own accord.
Push the choke lever (Item 6) back approximately
•
5 to 10 seconds after the engine has started.
8.2 Connecting consumers to the generator
Connect the 230 V~ electrical appliances to be
•
powered to the socket (Item 4). Important: This
socket is allowed to be exposed to a continuous
(S1) load of 850 W and temporarily (S2) for a
maximum of 300 second to a load of 900 W.
8.3 Overload cut-out
230 V socket
Reduce the level of power to be drawn.
•
Important: If an overload occurs, ensure that the
power drawn does not exceed the generator's
maximum power output and that no defective
electrical appliances are connected.
8.3.1 DC Application(option)
This usage is applicable to 12V battery charging
only.
a) charging instruction for battery,
output DC confined to the battery charging
capacity is less than 5Ahr-12VDC.
b) connect between the DC output socket and
the battery terminals using a charging leads. The
leads shall be connected making sure of the (+)
and (-)polarity.
c) reset button: Be used to the DC output outlet
Advertenties
Inhoudsopgave
