Equalizer Function - Ryobi R18R Gebruiksaanwijzing
Inhoudsopgave
Beschikbare talen
Beschikbare talen
installed, the battery symbol will be shown in the LCD
display. If the battery charge is low, a fl ashing low battery
indicator will be displayed.
MODE SELECTION
See page 146.
■
Press
to cycle through available modes.
There are four modes to choose from:
■
FM mode
■
AM mode
■
AUX mode
■
BLUETOOTH mode
NOTE: When turned on, the product will return to the last
mode that was used if the battery was not disconnected. In
the event power is lost to the product, the display will default
to FM mode.
ADJUSTING THE VOLUME
See page 146.
When the product is turned on, the product will return to the
last volume setting used.
■
To increase the volume, press
■
To decrease the volume, press
FM/AM TUNING
See page 147.
Use
and
to tune to the desired radio frequency. The
selected frequency is displayed on the LCD.
To tune frequency manually:
Briefl y push either
or
(not press and hold) to tune one
frequency step at a time.
1. Press and release to tune to a lower frequency.
2. Press and release to tune to a higher frequency.
To tune frequency automatically:
1. Press and hold or to tune frequency automatically.
2. Press or to stop scanning and select a frequency.
To decrease interference or electrical noise, adjust the
position of the antenna or move the product to a higher
elevation.
STORING A PRESET IN MEMORY
See page 148.
The memory feature saves up to 20 frequencies as presets
in the product's memory. You can save up to 10 frequencies
each for FM and AM modes.
Tune to the desired FM or AM frequency.
1. Press and hold
until "MEMORY" and the preset
position number flash on the screen.
4
Original Instructions
2. Press and to choose a preset position number.
3. Press
To tune to presets (fm or am mode):
■
EQUALIZER FUNCTION
To adjust the bass and/or treble settings:
1. Press and hold
2. Press
SETTING THE CLOCK
See page 149.
1. Press and hold
2. Press
.
3. Press and release
.
4. Press
5. Press and release
USING A PHONE/MP3 PLAYER (NOT INCLUDED) WITH
THE PRODUCT
See page 150.
NOTE: The retainer strap may be used to secure the device
into position.
1. Press
2. Connect auxiliary cable (not included) to the device.
3. For complete operating instructions for the connected
NOTE: There are 10 preset positions for FM and 10
for AM. Only one station can be saved in each preset
position.
again to store the frequency.
Press and release
to cycle through each preset
position number and its associated frequency.
until "b" (BASS) is displayed. Press
again and "t" (TREBLE) is displayed.
or
until the desired bass or treble level (–5 to
5) is achieved . Press
to store your selection.
until the hour time blinks.
or
to select the hour.
NOTE: Time is displayed in 12-hour format only. To
select an hour that is afternoon and before midnight,
cycle the hours until "PM" appears in the display.
to lock in the hour setting. Minute
time blinks.
or
to select the desired minute.
again to confirm the time.
until AUX mode is highlighted.
NOTE:
–
The phone/MP3 player must be on and in play mode
for sound to be heard through the speakers.
–
All phone/MP3 player controls can be used normally
while connected to radio.
–
Volume for any device connected through the
auxiliary cable can be adjusted using the volume
control for that device or by using
product.
–
Turning the product off will not turn the phone/MP3
player off.
–
The auxiliary cable does not provide charging
function.
device, always refer to the manual that was included
with your device.
or
of the
Inhoudsopgave
