Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Channel Setting
When other people are using Wireless Flash mode near you, your flash may be connected with the other
person's flash and your flash may fire. In this circumstance, please set
from that of the other person's.
Channel setting for Master unit
1. Press the MODE button to Select the
2. Press the SEL button several times to make the channel indicator blink.
3. Press the + or - button to set the channel number. (C1 〜 C4)
4. Press the SEL button several times to stop the blinking.
Channel setting for Slave unit
1. Press the MODE button to Select the ETTL／
2. Press the SEL button several times to make the channel indicator blink.
3. Press the + or - button to set the channel to the same number.
(C1 〜 C4) as the master unit.
4. Press the SEL button several times to stop the blinking.
◆ If the
channel number
different, the Slave will not fire. Please set the same number for Master and Slave.
Slave
Unit
ID Setting
When you use several Slave units, the Slave ID can be set to distinguish a Slave unit from Main flash.
◆ If you want to all Slave units to fire at the same flash output, this setting is not necessary.
1. Press the MODE button to Select the ETTL／
2. Press the SEL button
3. Press the + or - button and set the ID number. (1, 2 or 3)
4. Press the SEL button
◆ Repeat this process for each slave unit you are using, giving each one a different ID number.
Master Flash ON/OFF Setting
You can set the Master flash unit firing ON or OFF.
Master Flash unit firing ON
1. Press the MODE button to Select the
2. Press the + or - button to indicate the
Master Flash unit firing OFF
1. Press the MODE button to Select the
2. Press the + or - button to indicate the
Wireless ETTL Autoflash
In this Wireless ETTL Autoflash function, the camera automatically calculates the correct exposure.
Wireless ETTL Autoflash
If you require an equal power ratio for each flash
or 3
for each Slave Unit in
All the Slave flash units will fire at the same flash output and the ETTL autoflash system controls the total
flash amount automatically, to obtain a correct flash exposure.
The instructions below show how to reset the flashgun so no flash ratio is used and therefore equal power
is emmited from each flashgun.
◆ Please set the Master Flash unit as
1. Press the MODE button to select the ETTL ／
2. Press the
+ or -
button to display the
will not fire) in the LCD display.
3. Press the SEL button several times and confirm that the flash ratio is 1:1.
21
All manuals and user guides at all-guides.com
Preparation for Wireless Flash
mark.
of
the
Master and Slave
three
times to make the Slave ID indicator blink.
again so
the
display stops
mark.
mark.
mark.
mark.
(type A
cameras only)
with
Flash Ratio OFF
use.
follows:
mark (Master Flash will fire) or the shows
mark.
／
flashguns
are
mark.
／
blinking.
unit, the slave ID setting is not necessary. You can set 1, 2
mark.
a
different channel for your flash
(Master Flash
Advertenties
Inhoudsopgave
