Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
there are only two slave units, please select the
◆If
omitted).
Wireless Multi Flash
Set
the master flash unit as follows.
1.
Follow
the procedure for Changing
2. Press the SEL button to make the firing frequency display blink.
3. Press the + or - button to set the firing frequency.
4. Press the SEL button to make the flash output amount display blink.
5. Press the + or - button to set the flash output amount.
6. Press the SEL button to make the flash count display blink.
7. Press the + or - button to set the flash count.
8. Press the SEL button to make the
◆ The firing frequency and flash count will be the same for all slave units.
Slave Flash
◆ When
selecting
this mode with the MODE
MULTI) is not displayed.
Normal Slave Flash
Even if the EF-530 DG SUPER is not attached to the camera body, you can fire the flash by using the
camera's built-in flash or another flash
1. Attach the flash unit to the camera's hot shoe.
2. Set the camera's exposure mode to the desired mode. If you use A or M mode,
3. Turn on the flash unit
◆ Now, the aperture value and film speed are automatically
transmitted to the flash unit.
4. Remove the flash unit from
5. Press the MODE button and select the
6. Press the SEL button several times to make the flash output
indicator blink.
7. Press the
+ or
– button to set the flash output amount.
◆ Determine the appropriate flash
closely as possible with the actual distance from the slave flash to the subject. If the actual distance is
out of range, you
will
a.
To change the aperture value:
until the
aperture value blinks,
press the SEL button to stop the display blinking.
b.
To change the film speed:
indicator for the aperture value blink. Press the +
press the SEL button once again.
the slave mode.
8. Press the SEL button several times to make the display stop blinking.
9. Place the slave unit in the desired location. Do not place the slave unit within the
10.
After confirming
that all flash units are fully charged, press the shutter button to take the picture.
◆ When the EF-530 DG SUPER is fully charged, the AF Auxiliary Light will blink.
◆ The flash will not fire if the EF-530 DG SUPER is attached to the camera body while it is in the Slave
Mode setting.
◆ If you are using a Canon brand flash unit with ETTL function on your
flash unit as a slave unit, please do not use
slave to fire prematurely.
All manuals and user guides at all-guides.com
the Wireless
display
stop blinking.
button, make
unit.
and press
the shutter button half way.
the
camera.
/
output
by setting the distance indicator on the LCD panel to coincide as
need to change the aperture value
When the flash unit is set to the Slave mode, press the SEL button
then
press the +
Press MODE to select the ISO, then press the SEL button to make the
You will need to press the MODE button several times to return to
the
indicator at step 3 ( step 9 and step 10
Mode, and set to the MULTI／
sure that the
flash indicator mode
also
(Slave) mode.
value
or film
speed.
or
– button to set the desired aperture value. Then
or
– button and set the desired film speed, then
camera and
ETTL function, as the monitor pre-flash may cause the
should
mark.
(ETTL, M,
set the desired aperture
value.
picture
area.
the EF-530 DG Super
be
24
Advertenties
Inhoudsopgave
