5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.
5.2 Use
WARNING
The set-up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
START-UP
The device must be completely removed from its packaging and the protections must be completely removed.
Place the device on a solid, stable, flat and non-flammable surface.
Do not place the appliance against the wall.
Do not install the device near open fires or other heating devices.
It is forbidden to place flammable objects on and near the appliance.
Make sure that all ventilation openings are not blocked.
Make sure that the device is placed for optimal use.
The device must be electrically protected upstream with an adequate safety device.
The device should be plugged directly into a wall outlet, not a power strip.
Let the device heat up for 15 minutes before using it for the first time.
USE
Put your cooked fries in the tray.
Switch on the appliance by pressing the switch - the red button and the heating lamps light up.
REMARK
The appliance is fitted with a safety system in the event of overheating. If triggered, unplug the device and
allow it to cool. If this protection system operates regularly, it is imperative to contact our after-sales service
or your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the oil temperature to drop, then unscrew the plastic protection. by turning anti-
clockwise, press the reset button then screw the plastic protection back on.
EN