Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.3 Replacing the charcoal filter -
optional
Depending on type, filter can be or
cannot be regenerated. Refer to the
leaflet provided with the filter.
To replace the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. press the tab (1) and slightly tilt the front
of the filter. There are two charcoal filters.
One situated underneath (A) and the
other at the front side (B) of the
appliance.
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
The lamp does not operate.
3. To install a filter, perform the same steps
6.4 Replacing the lamp
This appliance is supplied with a LED lamp
and separate control gear (LED driver).
These parts can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Possible cause
The appliance is not connec‐
ted to a power supply or it is
connected incorrectly.
Lack of electrical power sup‐
ply.
The lamp is defective.
85
2
A.
2
B.
in reverse order.
Remedy
Check if the appliance is correctly connec‐
ted to the electrical supply.
Check the fuse or the main switch. If the
fuse or the switch continue to break the cir‐
cuit, contact a qualified electrician.
Replace the lamp. Refer to the "Care and
Cleaning" chapter.
1
1
1
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
