LUND 66906 Originele Instructies pagina 14
Inhoudsopgave
Beschikbare talen
Beschikbare talen
GB
that it fi ts the device housing's entire circumference (IV). Connect the device to the power supply by inserting
the power cord plug into the socket. The device is ready for use.
Warning! Never move the device with a fi lled tank.
Using the device
The device has a touch panel with three buttons. The button with the clock symbol is used to start the emission
of steam. The "ON" LED will light up to indicate continuous emission of steam. The subsequent pressing of
the button will start the timed steam emission mode. The mode is described by the number and letter H (e.g.
3H) and indicates the number of hours after which the device will automatically switch the steam emission off .
The device is switched off after touching the button the number of times required for all of the LEDs to stop
illuminating the operating mode. The steam emission will stop.
The button with the droplet symbol is used to increase and decrease steam emission. The steam jet's intensity
can only be set after the emission has started. If a single sound signal is heard after touching the button, it
means a higher intensity of the steam jet. A double sound signal means less intense steam jet.
The button with the sun symbol turns on the backlight and allows to control it. The fi rst touch of the button acti-
vates the automatic backlight colour change mode, the next touch stops the automatic backlight colour change
and leaves the backlight in the selected colour. The next touch of the button changes the intensity and colour of
the backlight. The backlight is switched off by touching and holding the button until the backlight is switched off .
DEVICE MAINTENANCE
Caution! All maintenance works must be carried out with the device's electric power supply disconnected. Pull
the plug from the power socket and disconnect the cord from the device.
Carefully open/remove the lid and pour water out of the device's tank. Water should be removed from the tank
not less frequently than every three days. Do not keep the water in the tank due to the possibility of growth of
microorganisms. Before refi lling, clean the tank with clean water. Remove any scale, sediments or fi lm which
has accumulated on the walls or inside the tank. Then wipe the tank dry. Pour one tablespoonful of citric acid
into the tank and 100 ml of warm water with the temperature not exceeding 70
C. Mix the acid and leave
O
the solution in the tank for 5 minutes. Next, empty the tank, rinse with clean water, and wipe dry omitting the
opening in the bottom of the tank under which the ultrasonic generator is mounted. This manner of maintaining
the tank will allow to keep it clean, reduce the growth of microorganisms, and prevent the build-up of scale in
the tank. Never use solvents, acids, or alcohol for cleaning. Clean the base and the lid with a soft, damp cloth.
Never immerse the device in water or any other liquid. After cleaning, leave the lid and the base with the tank
to dry completely. Store the device in a place protected from dust, moisture, and direct sunlight. Before fi rst
use, wipe the inside of the tank with a damp cloth.
14
O R I G I N A L
I N S T R U C T I O N S
Inhoudsopgave
