Technical Description; Control Elements; Installing The Kettle Holder; Using The Kettle - Dometic Perfectkitchen Mck750 Gebruiksaanwijzing

Waterkoker

Inhoudsopgave

Beschikbare talen

Technical description

The MCK750 kettle is intended for use in vehicles and is connected to a 12 Vg power supply or

24 Vg power supply, e. g. the on-board supply. It can be used to boil up to 750 ml of water.

The car-kettle may only be used in vehicles where the socket is protected with at least a 20 A fuse.

You can find details on the fuse in the vehicle documentation.

The kettle is automatically switched off when the water boils.

5.1

The car kettle has the following control elements:

No. in

fig. 1, page 3

Observe the following installation instructions:

• Make sure the installation location provides sufficient stability.

• Check beforehand that there is sufficient space on the other side for the drill head to come out.

• Make sure no concealed cables are damaged when drilling or screwing.

• Make sure the airbag function is not impaired.

To perform the installation, proceed as follows:

➤ Fasten the kettle holder with the screws supplied.

NOTICE!

• Use the device only when the vehicle is stationary, not while it is moving.

• Please immediately absorb any escaping fluid. Damage to the electronics may be

caused by moisture entering the device.

• Danger of scalding!

Empty the water tank carefully.

• Fill the water tank up to between the minimum and maximum mark (fig. 2,

page 3).

Designation

On/Off switch

Control lamp

MCK750

Inhoudsopgave

Inhoudsopgave