Inhoudsopgave
Advertenties
Wall or floor installation
The supplied holding fixture is intended for fastening the spotlight, either on a stable wall or on
the ground (stable substrate).
• It is not permissible to fasten the driver to the ceiling.
How to proceed:
1. Drill two holes with the indicated spacing.
2. Fasten the holding fixture.
– Use suitable fastening materials.
3. Insert a square nut into the spotlight on both sides.
4. Turn the clamping screws into the square nuts by several rotations on both sides, then insert
the spotlight in the holding fixture.
– If necessary, adjust the tilt of the spotlight. (→ Adjusting the tilt of the spotlight)
5. Tighten the clamping screws.
18
LAA0053
Advertenties
Inhoudsopgave
