Inhoudsopgave
Advertenties
Do not use the oven to cook extremely fatty meats or other products which increase flare-up.
The temperature under the oven is high. Do not place the oven on a table with flammable table
clothes, plastic or any other inflammable materials.
WARNING: When using the oven, do not touch the outer shell, stone baking board or immediate
surroundings as these areas become extremely hot and could cause burns
When the wind speed is above 2m/s, don't use pizza oven facing to the wind. The appliance is
designed for use outdoors only.
Do not modify the appliance.
Do not move the appliance while in use.
This appliance is not intended to be installed in or on a boat. This appliance is not intended to be
installed in or on a recreational vehicle.
Turn off the gas supply at the gas cylinder after use.
Any modification to the appliance may be dangerous and may cause injury or property damage. Any
unauthorised modification of the appliance will invalidate the guarantee on this appliance.
This appliance must be kept away from flammable materials during use.
The appliance must not have any overhead obstruction. E.g. trees, shrubs, lean to roofs. The
appliance must be installed with a clearance of 1M around the appliance.
The appliance must not be used near flammable materials. (Petroleum based products, thinners or
any other solid object that carries a flammable warning label.)
The use of this appliance in enclosed areas can be dangerous and is PROHIBITED.
INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your pizza oven and causing injury to
yourself and to property.
1.
Assemble the pizza oven by following the assembly instructions carefully.
2.
Connect the gas hose to the pizza oven. Connect the regulator to the hose.
3.
Connect the regulator to the cylinder valve following the regulator instructions supplied with the
regulator.
4.
Turn all of the control knobs to the 'OFF' position before turning on the gas supply to the
appliance.
5.
Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING YOUR PIZZA OVEN
1.
Open the door before lighting.
2.
Connect the gas cylinder to the pizza oven following the instructions supplied with the regulator.
3.
Turn the control knob to the 'OFF' position.
4.
Turn 'ON' the gas supply at the cylinder or regulator switch following the regulator connection
and operating instructions. Check the cylinder to regulator connection and hose to pizza oven hose
inlet connection for leakage using soapy water. Any leakage will show as bubbles in the area of the
leak. If leak is found, do not use the pizza oven. Consult your gas or pizza oven supplier for advice.
5.
To light the burner, push down the control knob and keep pressing whilst turning anti- clockwise
to the "Full rate" position and press the ignition button waiting for 5 seconds. This
will light the burner. Check that the burner is alight. If the burner has not lit, repeat this process.
6.
If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes before
retrying the ignition sequence.
7.
When the burner has lit, the burner rate can be adjusted by push down and turn the knob anti-
clockwise to any position between the full and low rate position.
Advertenties
Inhoudsopgave
