Advertenties
Original instructions: English
Translation of the original instructions:
Other languages
Read "the Safety Instructions" booklet
and the following before using.
I. INTENDED USE
These tools can be used to tighten
screws in clutch mode and to drill
holes in wood and metal in drill mode.
Additionally, model EY7940 can be
used to drill holes in soft concrete and
similar materials in hammer mode.
Read the Safety Instructions booklet
and the following before using.
II. ADDITIONAL
SAFETY RULES
1) Wear ear protectors.
Exposure to noise can cause hearing
loss.
2) Use auxiliary handle supplied with
the tool.
Loss of control can cause personal
injury.
EY7441_EY7940_EY7443_EY74A1_Book.indb 8
All manuals and user guides at all-guides.com
3) Hold power tools by insulated
4) Wear a dust mask, if the work causes
5) Be aware that this tool is always in an
6) When drilling or driving into walls,
7) I f t h e b i t b e c o m e s j a m m e d ,
8) Do NOT operate the Forward/Reverse
9) During charging, the charger may
10) When storing or carrying the tool,
11) Do not strain the tool by holding the
12) Do not operate the speed selector
- 8 -
gripping surfaces when performing
an operation where the cutting tool
may contact hidden wiring; contact
with a "live" wire will make exposed
metal parts of the tool "live" and shock
the operator.
dust.
operating condition, since it does not
have to be plugged into an electrical
outlet.
floors, etc., "live" electrical wires may
be encountered. DO NOT TOUCH
THE CHUCK OR ANY FRONT METAL
PARTS OF THE TOOL! Hold the tool
only by the plastic handle to prevent
electric shock in case you drill or drive
into a "live" wire.
immediately turn the trigger switch
off to prevent an overload, which can
damage the battery pack or motor.
Use reverse motion to loosen jammed
bits.
lever when the trigger switch is on.
The battery will discharge rapidly and
damage to the unit may occur.
become slightly warm. This is normal.
Do NOT charge the battery for a long
period.
set the Forward/Reverse lever to the
center position (switch lock).
speed control trigger halfway (speed
control mode) so that the motor stops.
switch (LOW-HIGH) while pulling on
the speed control trigger. This can
cause the rechargeable battery to
wear quickly or damage the internal
mechanism of the motor.
2012-12-11 9:21:07
Advertenties
