Inhoudsopgave
Advertenties
27.
Do not wind the power cord around the appliance during storage. This could cause damage to the cord
and lead to danger of short circuit, electric shock or fire.
28.
Should you accidentally allow the kettle to operate without water; the boil-dry protection will
automatically switch it off. If this should occur, allow the kettle to cool before filling with cold water and
re-boiling.
29.
Always take care to pour boiling water slowly and carefully without tipping the kettle too fast.
30.
Do not touch the hot surface. Use the handle or the button.
31.
Extreme caution must be used when moving an appliance containing hot water.
32.
The kettle is for household use only, not for outdoor.
33.
Our warranty does not cover water kettles that malfunction resulting from failure to descale.
34.
Do not boil anything but water in this water kettle.
35.
If you wish to stop the kettle before the water has boiled, you must switch off the appliance before
removing the kettle from its base.
36.
The kettle is only to be used with the base provided.
HOUSEHOLD USE ONLY
PARTS DESCRIPTION
1. Lid
2. Handle
3. Water gauge
4. On/off switch (a) and adjustable temperature control (b)
5. Power base
6. Anti-calc filter
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you clean your kettle before use by boiling
a full kettle of water twice and then discarding the water.
OPERATION OF YOUR KETTLE
1.
Open the lid; pour out left over water from previous boiling cycle and fill with the desired amount of fresh
water to the water kettle. Always fill the kettle between the minimum (0.5L) and maximum (1.7L) marks.
Too little water will result in the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before connecting the power cord to the outlet.
2.
Connect the plug into a power outlet. Press the on/off switch button "
starts to boil the water. The LED lights will illuminate red. The kettle will switch off automatically once the
water has boiled. You can shut off the power by pressing the switch button again at any moment during
boiling water.
NOTE: Ensure that switch is clear off obstructions and the lid is firmly closed all the time throughout the
boiling cycle. The kettle will not turn off if the switch is constrained and scalding may occur if the lid is
open.
3.
Once the water boils, wait 10 seconds before pouring out water to prevent hot steam from exiting through
the lid of the kettle. Lift the kettle then pour the water.
NOTE: operate carefully when pouring the water from your kettle as boiling water will scald.
4.
The kettle will not re-boil until the switch is pressed again. Allow to cool for 30~40 seconds before
reopening to boil water. Never re-boil water older than 2 hours.
NOTE: Ensure power supply is turned off when kettle is not in use.
- 3 -
" on the handle and the kettle
Advertenties
Inhoudsopgave
