To Configure The Cgc500; To Verify The Installation; To Recycle The Product; References - Ctek Cgc500 Handleiding
Beschikbare talen
Beschikbare talen
To configure the CGC500™
Configure the CGC500™ from the built in Web GUI accessed from the Ethernet interface marked "Service".
Note: To install and activate NanoGrid™ see "CCU NanoGrid Configuration Manual, Pd_CM_004".
2
1
4
1.
Activate NanoGrid™
1
3
2.
Upload NanoGrid.ini.
5
3.
Reboot.
8
To verify the installation
When the CGC500™ is configured and enabled enter: Nanogrid - > Grid UI in the WebUI.
1.
2.
3
2
To recycle the product
The product must be recycled as electronic equipment. Follow the local requirements for recycling of elec-
tronic equipment.
References
3
1.
CTEK AB
CTEK AB
Verify that all active charging stations are connected to the CGC500™ with a green mark in the "On-
line" column.
Connect an electric vehicle to a charging station. Verify that the electric vehicle gets allocated current
and that "State" is updated to "ActiveCharging".
CCU NanoGrid Configuration Manual, Pd_CM_004
1
2
9
Hoofdstukken
