Parkside PEHS 450 A1 Vertaling Van De Originele Gebruiksaanwijzing pagina 32
Beschikbare talen
Beschikbare talen
GB
MT
Problem
Device works with inter-
ruptions
Safety cutter bar (2) be-
comes hot.
Disposal/
environmental
protection
The device, accessories and pack-
aging should be properly recycled.
Waste electrical and electron-
ic equipment (WEEE) must not
be disposed of with domestic
waste.
The symbol of the crossed-out
wheeled bin means that this product
must not be disposed of as unsorted
municipal waste at the end of its use-
ful life.
Directive 2012/19/EU on waste
electrical and electronic equip-
ment:
Consumers are legally obliged to re-
cycle electrical and electronic equip-
ment in an environmentally sound
manner at the end of its life. In this
way, environmentally friendly and re-
source-saving recycling is ensured.
Depending on the implementation in
national law, you may have the fol-
lowing options:
• Return to a shop,
• Hand over to an official collection
point,
32
Possible cause
Power cord (8) damaged
Internal loose contact
Safety switch (5) or On/
Off switch (6) defective.
Safety cutter bar (2) blunt
Nicks on safety cutter bar
(2).
Too much friction due to
lack of lubrication
• Return to the manufacturer/distrib-
This does not affect accessories en-
closed with the old devices or tools
without any electrical components.
Service
Guarantee
Dear Customer,
This product is provided with a 3 year
guarantee from the date of pur-
chase. In case of defects, you have
statutory rights against the seller of
the product. These statutory rights
are not restricted by our guarantee
presented below.
Terms of Guarantee
The guarantee period begins on the
date of purchase. Please retain the
original receipt. This document is re-
quired as proof of purchase. If a ma-
terial or manufacturing defect occurs
within three years of the date of pur-
chase of this product, we will repair or
replace – at our choice – the product
for you free of charge. This guaran-
tee requires the defective product
and proof of purchase to be presen-
ted within the three-year period with a
brief written description of what con-
stitutes the defect and when it oc-
curred.
Error correction
Contact the service
centre.
Have the safety cutter bar
sharpened or replaced
(service centre)
Lubricate the safety cutter
bar (2)
utor.
