Original Accessories / Auxiliary Equipment; Initial Use; Adding Staples; Adding Nails - Parkside Phet 15 C2 Vertaling Van De Oorspronkelijke Gebruiksaanwijzing
Elektrisch spijker- en nietpistool
Inhoudsopgave
Beschikbare talen
Beschikbare talen
Original accessories /
auxiliary equipment
Only use the accessories and additional
equipment which are specified in the oper-
ating instructions and compatible with the
appliance.
Initial use
Always activate switch lock
lock the trigger
the product from the mains before
starting any works on the product.
Adding staples
Turn the product over.
Squeeze the release button
Then pull out the push rod
(see Fig. B).
4
Add staples to the magazine
After adding staples, slide the push rod
back to the magazine
Release button
3 a
place with the magazine
Note: Use the window on the fill indicator
to check if the magazine
7
use both fill indicators to check whether there are
still staples in the magazine.
Adding nails
Turn the product over.
Squeeze the release button
Then pull out the push rod
(see Fig. B).
4
Follow icon
shown on push rod
add nails to the magazine
After adding nails, slide the push rod
to the magazine
1
and disconnect
2
(see Fig. B).
3 a
from magazine
3
(see Fig. C).
4
till it is closed.
4
must click and lock in
properly.
4
5
is empty. You can
4
(see Fig. B).
3 a
from magazine
3
3
(see Fig. D).
4
back
3
till it is closed. Release
4
button
3 a
the magazine
Note: Use the window on the fill indicator
check if the magazine
Functions
Stapling and nailing
Press down switch lock
to
right to left to unlock position .
Press the safety contact
piece (see Fig. E).
Squeeze the switch trigger
the product against the work piece to drive
a staple / nail into it.
Note: Hold product firmly and press on work
surface before firing to ensure complete penetra-
tion of the staple / nail.
Clearing jammed
staples or nails
3
or
starting any works on the product.
Open the magazine
push rod
3
Remove the jammed staple or nail from the
magazine
Choosing the correct length
of nails and staples
Consider 2 factors to choose the correct
and
length for staples and nails:
- the thickness of the material to be fastened
- the composition and hardness of the base
material.
must click and lock in place with
properly.
4
is empty.
4
completely from
1
into the work
6
whilst holding
2
Always activate switch lock
lock the trigger
and disconnect
2
the product from the mains before
and pull out the
4
.
.
4
to
7
to
1
GB/IE
21
Hoofdstukken
Inhoudsopgave
