Cleaning and storage
Disconnect the product
from the wall outlet during
periods of disuse and
before cleaning.
Instructions on cleaning
the product: see
"Cleaning"
Store the product in a
cool, dry place protected
from sunlight and out of
the reach of children.
First set-up of the product
Unpacking the product and
basic cleaning
1. Take the product out of the packaging
and remove all packaging materials
and plastic wrappings.
2. Check to make sure that all listed
parts are included (see "Scope of
delivery .
3. Check whether the product and all
parts are in good condition. If any
damage or defect is detected, do
not use the product, but follow the
procedure described in chapter
"Warranty".
4.
e ore rst use clean all parts o the
product as described in the chapter
"Cleaning".
Mounting the cable rewind
Required tool: Phillips screwdriver
o
ount the cable rewind
o
screws
[
]
onto the
holes
9 ]
[
ig.
Setting up the product
INFO: The anti slip eet
a secure stand of the product.
[
]
with
screw
.
[
]
guarantee
Place the product on an even,
o
horizontal and stable surface.
Maintain the following clearances
o
around the product:
–
cm to the le t right top and rear
–
cm to the front
Operation
INFO: The product may give o some
vapours or odours during rst use.
These are production or transport
residue that will quickly subside.
There may also be quiet noises such
as clicking or crackling. These will
also quickly subside once the plastic
parts have nally adjusted to the
operating conditions.
Switching the product on
INFO:
Make sure that the supply voltage
o
of the mains outlet meets the
requirements described in the
"Technical data" chapter.
Depending on the position of the
o
heating level switch
indicator
2 ]
[
is switched on or o
Position
Power indicator
Switched on
Switched o
1. Set the temperature controller
to
position and the heating level
switch
3 ]
[
to
position.
2.
onnect the mains plug
RCD-protected mains outlet.
3 ]
[
the power
1 ]
[
to an
[
]
GB/IE
35