Parts And Operating Components; Usage - Parkside Pds 30 B1 Gebruiksaanwijzing
Plafondsteun
Inhoudsopgave
Beschikbare talen
Beschikbare talen
Parts and operating components
(See fold-out page for illustrations)
The ceiling prop PDS 30 B1 consists of the following parts:
▯
Rubber pad
▯
Upper bar
▯
Pump lever
▯
Lower bar
▯
Locking screw
▯
Tube
▯
Locking bolt
▯
Locking lever
Usage
♦
Loosen the locking screw
♦
If necessary, press the two locking bolts
pull the lower bar
is located under the load to be supported (Fig . C) .
♦
Allow the two locking bolts
Use the red line which marks the position of the locking bolts
on the lower bar
♦
If the length of the lower bar
upwards (Fig . E) and pull the upper bar
♦
Re-tighten the locking screw
♦
To make fine adjustments to the height, press the pump lever
until the rubber pad
(Fig . G) .
♦
To loosen and remove the prop, press the locking lever
upper bar
♦
Loosen the locking screw
♦
Hold the tube
out of their detent (Fig . B) .
♦
Push the lower bar
■
4
│
GB │ IE │ NI
1
2
3
4
5
6
7
8
5
out up to the required height until the rubber pad
4
as an orientation aid .
4
is located firmly under the load to be supported
1
has been completely retracted (Fig . H) .
2
5
firmly with one hand and press the engaged locking bolts
6
back inside completely .
4
(Fig . A) .
out of their detent (Fig . B) and
7
to engage completely in the tube
7
is insufficient, push the locking lever
4
out to the required height .
2
(Fig . F) .
5
(Fig . A) .
1
detent .
6
(Fig . D)
7
8
several times
3
upwards until the
8
7
PDS 30 B1
Hoofdstukken
Inhoudsopgave
