emerio IM-111502 Gebruiksaanwijzing pagina 8
Beschikbare talen
Beschikbare talen
BEFORE USE
1. Remove all the packaging; take out the ice scoop and backup silicon plug.
2. Place the appliance on a stable and flat surface. Keep the appliance away from heat sources and direct
sunlight; keep it in a well-ventilated place and leave at least 20cm space near the air inlet and outlet.
3. Clean the appliance and its components (See "CLEANING AND MAINTENANCE").
Caution! Do not use outdoors. Do not use the appliance in a too cold or too hot environment. When the
environment temperature is lower than 5 ℃ or higher than 43 ℃ , the appliance will have problems in making
ice.
HOW TO USE
Do not use the appliance within 30 minutes after transportation. Switching on the power too early might cause
damage to your Ice Cube Maker.
1. Take out the ice cube bucket. Pour water (only water conformed to drinking standard) into the water tank.
Pay attention that the water line should never stay beneath the "H-MIN" mark nor exceed the "H-MAX" mark.
Place back the ice cube bucket when water has been poured.
2. Put the plug into the power outlet. There is a beep sound and the LCD display will light up. Now the appliance
is ready for use.
3. Press the "SELECT" button to choose the size of ice cube. Different sizes will lead to different time for making
process. The default size is Medium size.
S = Small (this will take approximately 9 minutes)
M = Medium (this will take approximately 11 minutes)
L = Large (this will take approximately 13 minutes)
4. Press the
button to start making ice. The LCD display will have the snow flake icon flashing to indicate
the ice making process is on-going. You can press
will stop at once and you may find some incomplete ice cubes.
5. After about 9-13 minutes (depending on the cube size), the first batch of 9 ice cubes will be produced and
dropped into the ice cube bucket. You can also check through the transparent window on the top.
Note! The produced ice cubes in the bucket will melt gradually so please use the
scoop to take out the ice cubes in time. The melted water will be collected into the
water tank. If you want to remove the left water in water tank, screw off the little
cap (a) anticlockwise (at the back of appliance) and take out the silicon plug (b),
then you can drain the water tank.
Ice full indication
If the ice cube bucket is completely full with ice cubes, the icon
sound for a reminder. Take out the ice cubes and then press
Water shortage indication
When the water line drops beneath the "H-MIN" mark, it means there is a water shortage, the icon
on the LCD and a beep sound reminder will be sent out. Fill more water and then press
making ice, the
icon will become still.
All manuals and user guides at all-guides.com
- 7 -
at any time to stop the ice-making, the program
will appear on the LCD and emit a beep
button, the icon
will turn to
.
will flash
button to resume
