Inhoudsopgave
Advertenties
Note: UT is the A.C. mains voltage prior to application of the test level.
Guidance and manufacturer's declaration — electromagnetic immunity
The AA222 is intended for use in the electromagnetic environment specified below. The customer or the user
of the AA222 should assure that it is used in such an environment,
Immunity test
Conducted RF
IEC / EN 61000-4-6
Radiated RF
IEC / EN 61000-4-3
NOTE1 At 80 MHz and 800 MHz, the higher frequency range applies
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and
(a)
land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted
theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an
electromagnetic site survey should be considered. If the measured field strength in the location in which the
AA222 is used exceeds the applicable RF compliance level above, the AA222 should be observed to verify
normal operation, If abnormal performance is observed, additional measures may be necessary, such as
reorienting or relocating the AA222.
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
(b)
D-0119998-D – 2022/12
AA222 – Gebruikshandleidung - NL
IEC / EN 60601
test level
3 Vrms
150kHz to 80 MHz
3 V/m
80 MHz to 2,5 GHz
Compliance level
3 Vrms
3 V/m
Electromagnetic environment –
guidance
Portable and mobile RF
communications equipment
should be used no closer to any
parts of the AA222, including
cables, than the recommended
separation distance calculated
from the equation applicable to
the frequency of the transmitter.
Recommended separation
distance
d
, 1
2
P
=
, 1
2
d
=
P
80 MHz to 800
MHz
d
=
2
3 ,
P
800 MHz to 2,5
GHz
Where P is the maximum output
power rating of the transmitter in
watts (W) according to the
transmitter manufacturer and d is
the recommended separation
distance in meters (m).
Field strengths from fixed RF
transmitters, as determined by an
electromagnetic site survey, (a)
should be less than the
compliance level in each
frequency range (b)
Interference may occur in the
vicinity of equipment marked with
the following symbol:
Pagina 84
Advertenties
Inhoudsopgave
