Download Inhoudsopgave Inhoud Print deze pagina

Door Adjustment - Dik Geurts Jannik Medium, Low Installatiehandleiding

Verberg thumbnails Zie ook voor Jannik Medium, Low:
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

9.3.3 Door adjustment

Check the closing of the door during installation or maintenance. The door can be adjusted if desired.
This will be the case if sealing is insufficient (gaps).
Ø
Check the sealing of the door by placing a sheet of paper between the door and the fire. After closing the door, it
should not be possible to pull out the sheet of paper easily. Check the outside of the fire.
For appliance-specific information concerning door adjustment, we would like to refer you to section 9.3.3.1.
9.3.3.1 Door adjustment
At delivery and during maintenance you should check the play in the door and how the door closes. In case of a
door that does not open and close smoothly, there are a number of measures that you can take. For instance:
You can adjust the door by slightly moving the door catches (see Appendix 2, fig. 3).
To do this proceed as follows:
Ø
Loosen the nuts a little.
Ø
Adjust the door catches.
Ø
Then re-tighten the nuts properly.
Ø
Check whether the sealing tape makes a good connection by clamping a sheet of paper between the fire and the
sealing tape when closing the door.
Ø
It should not be easy to pull out the sheet of paper. If necessary, adjust the door.
Is the door not properly sealed?
Ø
Replace the insulating rope (see appendix 2, fig. 14)
Ø
Adjust the door handle.
When replacing the cord, please proceed as follows:
Ø
Open the door.
Ø
Remove the cord and sealant from the gutter.
Ø
Apply a new layer of high temperature resistant sealant in the gutter that contained the cord.
Ø
Place a new cord in the gutter. Do this loosely, do not pull the cord tight.
Ø
Insert both ends of the cord in a special sleeve.
Make sure the sleeve is placed at the bottom side of the glass pane.
!Caution
When adjusting the door, please proceed as follows:
Ø
Slightly loosen the nuts.
Ø
Adjust the catches.
Ø
Then properly re-tighten the nuts.
Ø
Check that the sealing tape properly connects when closing the door by clamping a sheet of paper between the
appliance and the sealing tape.
Ø
It should not be easy to pull out the paper. Adjust the door, if necessary.
44
apply a little bit of heat resistant grease on the shaft of the seal;
adjust the door.
I N S T A L LA T I ON M A N U A L

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Jannik medium, high, jannik large-01

Inhoudsopgave