About the "InfoLITHIUM" battery
pack
•Frequently using the LCD panel or frequently
operating playback, fast forward or rewind
wears out the battery pack faster. We
recommend using the large capacity battery
pack (NP-FF70, optional).
•Be certain to turn the POWER switch to OFF
(CHG) when not taking shots or playing back
on your camcorder. The battery pack is also
consumed when your camcorder is in the
standby mode or playback is paused.
•Have spare battery packs handy for two or
three times the expected recording time, and
make trial recordings before taking the actual
recording.
• Do not expose the battery pack to water. The
battery pack is not water resistant.
Remaining battery time indicator
•If the power goes off although the remaining
battery time indicator indicates that the battery
pack has enough power to operate, charge the
battery pack fully again so that the indication
on the remaining battery time indicator is
correct. Note, however, that the correct battery
indication sometimes will not be restored if it is
used in high temperatures for a long time or left
in a fully charged state, or the battery pack is
frequently used. Regard the remaining battery
time indication as the approximate shooting
time.
•The E mark indicating little remaining battery
time sometimes flashes depending on the
operating conditions or ambient temperature
and environment even if the remaining battery
time is about five to ten minutes.
264
Over "InfoLITHIUM" batterijen
•Bij intensief gebruik van het LCD scherm of
veelvuldig wisselen tussen afspelen,
vooruitspoelen en terugspoelen zal de batterij
sneller leegraken. Gebruik zo mogelijk een
batterijpak met hoge capaciteit (NP-FF70, los
verkrijgbaar).
•Zet altijd de POWER schakelaar terug op "OFF
(CHG)" wanneer u de camcorder niet meer
voor opnemen of afspelen gebruikt. De batterij
raakt ook leeg wanneer de camcorder in de
opnamepauzestand of weergavepauzestand
staat.
•Houd voldoende reserve-batterijen bij de hand
voor twee- of driemaal de verwachte
opnameduur, en maak ook proefopnamen voor
u de uiteindelijke opname maakt.
•Laat uw batterijpakpen niet nat worden. Deze
batterijpakken zijn niet waterbestendig.
Aanduiding van de resterende
batterij-gebruiksduur
•Als de camcorder vanzelf wordt uitgeschakeld,
terwijl de batterijspanningsindicator aangeeft
dat er nog voldoende spanning over is, laad
dan de batterij opnieuw volledig op. Dan zal
weer de juiste batterijcapaciteit worden
aangegeven. Soms kan echter niet de juiste
batterijcapaciteit getoond worden als het
batterijpak geruime tijd achtereen aan hitte is
blootgesteld of lang in volledige opgeladen
toestand is blijven liggen, of als het batterijpak
erg intensief is gebruikt. De aangegeven
resterende batterij-gebruiksduur is geen
absoluut gegeven, maar een benadering van de
beschikbare gebruiksduur.
•Soms kan de E batterij-leeg aanduiding gaan
knipperen vanwege de omgevingstemperatuur
of andere opname-omstandigheden, ook al
kunt u de batterij in feite nog vijf tot tien
minuten langer gebruiken.