Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
D. Fix mounting plate with 8 pcs of M6x15 bolt using allen wrench
D-1
Parts required, allen wrench and eight(8) of
M6×15 bolt
E. Cable holder installation 1
E-1
Place cable holder 30 cm away from the rear center of the antenna. Apply masking tape 5 mm from
away the outside of holder
E-2
Drill a 20 mm hole in the center of the
tape marking
D-2
Place the antenna on mounting plate and
tighten firmly each bolt by allen wrench
E-3
Make sure that hole size is minimum so that the
cable can pass through
ENGLISH - 20
Advertenties
Hoofdstukken
Inhoudsopgave
