Download Inhoudsopgave Inhoud Print deze pagina

Zanussi ZTH 475 Gebruiksaanwijzing pagina 24

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

drum turns alternately in both directions during
drying.
All drying programmes end with a 10 minute
cooling phase. You may remove the laundry af-
ter this phase.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again af-
ter closing the door in order to restart the pro-
gramme from the point at which it was interrup-
ted. This button must be depressed also after a
power failure and after having reinserted the
water reservoir, if it has been emptied in the
middle of a programme after lighting up of light
Water Tank .
In both cases the light of the Start/Pauze
(Start/Pause) button flashes to remind you that
the start button needs to be pressed again.
Indicator lights
These lights indicate the following functions:
• Drogen (Drying) light: This light indicates
that the appliance is in the drying phase.
• Anti-kreuk/Einde (Anticrease/End) light:
This light is on at the end of the cooling
phase, during the anticreasing phase and at
the end of the programme.
• Waterreservoir (Water Reservoir) light:
This light indicates that the appliance is in
the drying phase. This light comes on at the
end of the programme to remind you that the
water reservoir must be emptied out. If this
light illuminates during a programme this
means that the water reservoir is full. The
buzzer sounds, the programme stops, the
light of the Start/Pauze (Start/Pause) button
flashes. This light comes on also when the
water reservoir is not inserted correctly.
• Filter light: This light illuminates at the end
of the programme to remind you that the fil-
ters must be cleaned.
• Condensor (Heat exchanger) light: This
light indicates that the heat exchanger fluff
filters in the base of the appliance must be
cleaned ,i.e. after each 3 drying cycles
2) Only dryers with buzzer button
24
Changing programme
To change a programme which has been selec-
ted by mistake once the programme has star-
ted, first turn the programme selector to
OFF position. The programme is cancelled.
The programme can no longer be changed
directly once the programme has started. If
nevertheless there is an attempt to change the
programme on the programme knob or if an
function button (excluding the Zoemer (Buz-
2)
zer) button
) is pressed, led on the Start/
Pauze (Start/Pause) button starts flashing tem-
porarily in red. The drying programme is not
however affected by this (laundry protection).
At the end of the programme
If the laundry is not removed at the end of the
cycle, the dryer performs an anticreasing phase
(duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will
stop automatically at the end of the anticreas-
ing phase. Lights Anti-kreuk/Einde (Anti-
crease/End) , Filters and Waterreservoir
(Water Reservoir) remain lit and the buzzer
sounds for 2 minutes.
Turn the programme selector dial to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty.
If you do not intend to carry out another wash,
close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant
smells.
If you open and then close the door before
turning the selector dial to
corresponding to the phases making up the
performed programme come on.
After each use
• Clean the filters.
• Empty the water reservoir.
to
all the lights
www.zanussi.com

Advertenties

Inhoudsopgave
loading

Inhoudsopgave