•
•
•
Install the unit on a wall that can withstand its weight. Insufficient physical strength may cause the equipment
to fall and possible injury.
•
•
lations and this manual using a separate circuit. Insufficient capacity of the power supply circuit or improper
•
Be sure to install a ground fault circuit interrupter according to local laws and regulations. Failure to install a
•
tected from water and other adverse external forces. Incomplete connection or affixing may cause a fire.
•
When wiring the power supply, form the wires so that the front panel can be securely fastened. If the front panel
•
•
during and immediately after operation as the refrigerant pipes may be hot or cold, depending on the condition
of the refrigerant flowing through the refrigerant piping, compressor and other refrigerant cycle parts. Burns or
frostbite are possible if you touch the refrigerant pipes. To avoid injury, give the pipes time to return to normal
temperature or, if you must touch them be sure to wear protective gloves.
•
internal parts can cause burns. To avoid injury, give the internal parts time to return to normal temperature or, if
you must touch them, be sure to wear protective gloves.
EN
74
Cod. 354M000010 - Rev. 03 - 06/2023
OMNIA SW-T 3.2
-
-
-