Getting Started; Installing The Filter; Setting Up The Remote Control; Using The 3-In-1: Air Purifier, Fan And Heater - Philips Amf220 Handleiding
Verberg thumbnails
Zie ook voor AMF220:
- Handleiding (328 pagina's) ,
- Gebruikershandleiding (290 pagina's)
2
Getting started
Installing the filter
Note: Make sure the appliance is unplugged from the electrical outlet before installing the filter.
1
To remove the back cover, hold the side of it with both hands and pull (fig
2
Pull the filter from the appliance (fig
3
Remove all packaging materials from the filter (fig
4
Put the filter back into the appliance (fig
5
Reattach the back cover (fig
Setting up the remote control
1
Pull out the plastic film on the remote control to activate the battery (fig
2
Pair the remote control with the appliance if you have multiple devices in one house
(see the chapter "Pairing your remote control").
Note: Place the remote control in the slot and it snaps in place automatically (fig
3
Using the 3-in-1: air purifier, fan and heater
Air quality light
PM2.5 level
≤ 12
13-35
36-55
> 55
Turning on and off
Note:
• Plug the appliance into the power outlet; do not use a power strip.
• If the appliance is running in heating mode when you turn it off, it continues working for 20 seconds
to exhaust the remaining heat. Counting down will show on the display panel.
1
Press
to switch on the appliance.
2
The display panel lights up, and appliance shows the PM2.5 level and temperature (fig
3
Press
to switch off the appliance.
)�
e
)�
f
)�
g
)�
h
Air quality light color
Blue
Blue-purple
Purple-red
Red
)�
d
)�
i
)�
j
Air quality level
Good
Fair
Poor
Very poor
)�
k
EN
3
Hoofdstukken
Probleemoplossen
