Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
not touch the mixing paddle
with your hands while the device
is operating. This could cause
serious injuries.
If parts get stuck, disconnect the
mains plug from the mains socket.
Then attempt to remove the in-
gredients which are impeding
the mixing paddle
If maintenance is required, please
contact the service point.
Before each use, please check
the mains cable
mixing chamber
paddle
and the other remov-
5
able parts for damage. If you
find damage, please contact the
service address for a replacement.
To prevent hazards, ensure that
all elements have been fixed in
the correct place before you con-
nect the product to the power
supply.
Do not use the microwave or
other sources of heat to disinfect
the product. This could cause
deformation and defects.
Do not clean the product with
steel wool, scouring agents or
corrosive liquids.
Do not expose this device to
sunlight for prolonged periods.
This could cause decolouration.
24 GB/IE
5
.
5
, the plug, the
3
, the mixing
1
Do not heat any parts of this
product.
Before first use
To prevent hazards, make sure that the device
is complete and the device, mains plug and
mains cable
are in good condition after
3
unpacking to rule out possible damage.
The device is packaged to protect it from trans-
port damage.
Carefully remove the device from the retail
packaging.
Remove all parts of the packaging and remove
the protective film from the display.
Thoroughly clean the device and all accessories
as specified in chapter „Cleaning and care".
To do so, you will first have to disassemble the
device. Follow the instructions in the chapter
„Disassembling the product".
After it has been thoroughly cleaned and re-as-
sembled (see chapter „Assembly"), set up the
pasta machine in the vicinity of a safety socket.
Make sure it is easily accessible.
Furniture nowadays is coated with a variety of
varnishes and plastics, and is treated with the
most diverse of care products. It is therefore im-
possible to rule out that some of these substances
may contain components which would attack
and soften the rubber feet of the housing
necessary, place an anti-slip pad under the
pasta machine.
Place the device on a suitable surface.
Connect the mains cable
the back of the device.
Connect the device to the safety socket.
Disassembling the product
Make sure that the device is switched off and
unplug the mains plug from the socket before
disassembling.
Remove the lid
from the housing
4
erating the release catch
. If
2
with the socket on
3
by op-
2
and then pulling
4a
Advertenties
Hoofdstukken
Inhoudsopgave
