Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
occurs. Stop the treatment if this occurs. Alternatively, increase the radiation distance and/or reduce the
radiation duration.
• This device is not intended for radiation from above.
• The minimum distances described in these instructions for use must be adhered to.
• If the appliance is operated continuously, caution and attention are advisable - never fall asleep during
radiation!
• Prolonged use can cause burns to the skin.
• Do not touch the infrared lamp or unscrew it when it is connected to the mains.
• Children do not understand the risks associated with electrical appliances. Make sure the appliance inot
used by children without appropriate supervision.
• The appliance may be used only under supervision.
• Keep children away from packaging materials (risk of suffocation).
• Do not cover up or pack away the unit while it is warm.
• Always remove the mains plug and let the unit cool off before you touch it.
• Do not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed onto the
unit. The unit must be operated only when it is completely dry.
• Protect the unit from strong impacts.
• Do not pull the mains plug from the socket by the cord.
• In the event of a defect or malfunction, switch the device off immediately and disconnect it from the power
supply.
If the power cord of the device is damaged, it must be replaced by the manufacturer or an authorised
customer service technician in order to avoid hazard.
• Disconnection from the mains supply is only guaranteed if the mains plug has been removed from the socket.
• There is a risk of strangulation for babies and children who become trapped in the mains cable.
General notes
Important
• Product is not suitable for lighting rooms in private homes.
• This unit is not intended for commercial or clinical use, but only for individual, private household use!
• If you have health concerns of any kind, contact your general practitioner!
• Before you use the unit for the first time, remove all packaging materials.
Lighting is excluded from the warranty.
•
Repairs
Important
• Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious
injuries. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.
4. Initial use
Setup
Remove the unit from the packaging. Remove all packaging material before using the appliance. Before use,
check whether the infrared lamp is properly screwed in. Place the device on flat surfaces. The appliance has an
adjustable lampshade. Set the angle of the fluorescent screen in accordance with your individual requirements.
Mains connection
Connect the unit only to the mains voltage listed on the type plate.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.
Replacing the fuse (UK plug only)
If the fuse needs replacing, please observe the following:
• Remove the mains plug
• Lift out the fuse holder from the inside of the mains plug using a flat screwdriver
• Pull out the fuse from the fuse holder and replace it with a new fuse type: 3A (breaking capacity 6 kA at 240 V)
in accordance with BS-1362 / SS167.
• Press the fuse holder containing the new fuse into the plug slot
• Plug the mains plug into the socket and test to see if it works.
9
Advertenties
Hoofdstukken
Inhoudsopgave
