For Your Safety; Lighting - Atag W G3X Maxus Gebruiksaanwijzing
Inhoudsopgave
Beschikbare talen
Beschikbare talen
for your safety
Please note
This appliance should be connected by a
registered fitter. Damage arising from incorrect
connection or incorrect fitting is not covered by
the guarantee.
Disconnect the appliance before starting w ith
cleaning or reparation. It is recommended that
you do this by removing the plug from the
socket or by setting the isolation sw itch to zero.
Never flambe under an extractor. The high
flames can cause fire. Even if the ventilator is
sw itched off.
W hen deep-frying, alw ays keep a close w atch.
If the appliance is used together w ith
equipment w hich uses gas or other fuels, then a
sufficient supply of fresh air must be ensured.
Sw itch the extractor hood on before starting to
cook. After cooking, allow the extractor hood to
continue to run for approx. 10 minutes. This can
also be done automatically (see 'automatic
continued running').
Clean the appliance regularly, as show n in
'maintenance'. This minimises the chance of a
fire starting.
GB 2
Sw itch off the electricity before replacing the
light bulbs! Only use the same sort of light bulbs
w ith the same Wattage.
In view of possible sharp edges on the chimney
w e advise you to w ear w orking gloves w hen
fitting the chimney.
lighting
sw itching on the appliance
First sw itch the appliance on using the on/off button
light above the button lights up. You can now make use of the
other function symbols.
sw itching on the lighting
Touch the
You can adjust the light intensity (1-4) by keeping your finger
on the button. After a few seconds, the lighting jumps to the
next setting (in the sequence 4-3-2-1-0-1-2-3-4). The number
of indicator lights on above the
intensity.
sw itching off the lighting
Touch the
indicator light above the symbol goes out.The lighting also
goes out if you sw itch the appliance off using the on/off
sw itch.
fan
sw itching on the appliance
Sw itch the appliance on using the on/off button (
light above the button lights up. You can now make use of the
other function symbols.
sw itching on the fan
Touch the
setting you w ant has been reached. If you continue to keep
your finger on the symbol, after a few seconds the setting w ill
jump to the next setting (in the sequence 0-1-2-3-4-3-2-1-0).
The indicator lamp above the symbol indicates the setting.
10
20
-symbol. The lighting sw itches on at setting 4.
-symbol indicates the light
-symbol and keep your finger on it until the
-symbol and keep your finger on it until the
. The
). The
Hoofdstukken
Inhoudsopgave
