Fan; Intensive Setting; Faults - Atag W G3X Maxus Gebruiksaanwijzing
Inhoudsopgave
Beschikbare talen
Beschikbare talen
fan
(continued)
adjusting extractor capacity
Touching the
setting. The new setting is indicated by the indicator lights
(0-4) lighting up.
intensive setting
Keep your finger on the
lights come on. Let go of the button and the setting is
sw itched on.
sw itching the fan off
Touch the
indicator lights go out. W hen you let go of the button, the
hood sw itches off.
automatic continued running
First select the fan setting desired. Touch the
You can choose w hether the extractor hood is turned off
after 10 or after 20 minutes. The light next to the time
selected lights up.
The extractor hood automatically sw itches back from the
setting chosen to 0. If the lighting w as sw itched on during
the automatic continued running, it w ill remain sw itched on.
cleaning the grease filter
If the grease filter symbol (
the filter immediately.
Put the filter back in place after cleaning and erase the
electronic memory by touching the symbol
your finger on it until the indicator light goes out.
GB 4
10
20
- symbol sw itches the fan to its next
- symbol until the 4 indicator
- symbol and keep your finger on it until all the
- symbol.
) lights up, you should clean
and keeping
faults
Please check the follow ing points w hich may solve the problem, before calling the service
department.
If the connection cable is damaged, it should be replaced by the service department of the
manufacturer or similarly qualified persons in order to prevent dangerous situations from arising.
NB: Disconnect the appliance from the mains before starting any repairs, preferably by removing
the plug from the socket or by setting the isolation sw itch to zero.
fault
cause
Lighting does not w ork.
Lamp defective.
NB:
Only use the same type of lamp
w ith the w attage stated.
Extractor hood makes a lot of
Discharge duct too long or has
noise.
too many bends.
M otor defective.
No extraction.
M otor or controls defective.
Connection lead defective.
solution
Pull the inner ring dow nw ards
using a screw driver (see
illustration).
NB: the glass is loose!
Pull the halogen lamp out of
the fitting and replace it w ith a
new 20 W halogen lamp (w all
hoods) or 10 W halogen lamp
(island hoods). Use a clean
cloth to hold the new lamp.
Change the discharge duct
(see installation instructions).
Phone the Service department.
Phone the Service department.
Phone the Service department.
GB 5
Hoofdstukken
Inhoudsopgave
