Power Button - Winix Zero S Gebruikershandleiding
Inhoudsopgave
07. Filter Reset Button
After replacing the True HEPA Filter, use a small object
such as a paper clip, to press and hold the Filter
Reset Button for at least 5 seconds until the Filter
Replacement Indicator turns off .
08. Power Button
Turns the unit on or off . During the first 30 seconds
of powering up, the Air Quality Indicator will cycle
through Blue, Amber and Red colors .
• Dust Sensor takes approximately 30 seconds to
gauge the air quality in the environment before
normal detect begins .
09. Mode Button
Press to cycle through to set the mode of operation
(Auto, Sleep) . The unit will default to Auto with
PlasmaWave
®
enabled when first powered on .
Auto Mode:
• Auto Mode automatically adjusts fan speeds
according to your indoor air quality . The fan speed
will adjust to low when air quality is good, medium
when fair, and to high when poor .
Sleep Mode:
When Sleep Mode is activated, the Air Quality
Indicator LED light is disabled .
• Fan speed will automatically set to minimum speed
(lower than 'Low') which will be nearly silent .
• When Sleep Mode is active, PlasmaWave
disabled, but it can be turned back on .
6
Zero S
10. PlasmaWave
Press the Plasmawave
on to enable or disable this feature . By default,
PlasmaWave
powered on .
"When the unit is running, you may hear a chirping
or buzzing sound . The sound is from large particles
passing through PlasmaWave
not signify product failure ."
11. Light Sensor
Detects the amount of ambient light in the
environment . When in Auto Mode, the Light Sensor
detects when to put the unit into Sleep Mode .
®
will be
®
Button
®
button when the unit is
®
is enabled whenever the unit is
®
, it is normal and does
English
Inhoudsopgave
