Inhoudsopgave
Advertenties
Part
* Set the switch for hard floor/carpet
according to the floor type:
Switch position
˜ Attaching accessories
1. Connect the hose
[
1 ]
hose must audibly lock in place (Fig. B).
2. Insert the handle of the hose into the wide
opening of the telescopic tube
3. Set the telescopic tube to the desired length:
–
Slide the telescopic tube lock
and adjust the length of the telescopic
tube (Fig. D).
–
Release the telescopic tube lock.
–
If necessary, slightly adjust the length until
the telescopic tube lock locks in place.
4. Insert the telescopic tube into the intake of
the floor brush
, the nozzles
15 ]
[
furniture brush
18 ]
[
INFO:
The nozzles and the furniture brush can be
directly attached to the hose.
Prior to usage: Ensure all accessories are
securely fastened.
The nozzle holder
telescopic tube.
Application
Blinds
18 ]
[
Louvres
Delicate surfaces
[
14 ]
Floor type
Hard floor
Carpet
with the intake
. The
13 ]
[
(Fig. C).
[
2 ]
forward
20 ]
[
or the
[
16 ]
17 ]
[
(Fig. E).
can be attached to the
[
19 ]
19 ]
[
2 ]
[
The following accessories can be attached to
the nozzle holder when not in use:
–
Upholstery nozzle
–
Crevice nozzle
–
Furniture brush
˜ Switching on/off
1. Pull the power plug
least until the yellow marking. When the red
marking appears, the end of the power cord
has been reached. Do not pull out the power
plug any further (Fig. F).
2. Connect the power plug to a socket-outlet.
3. Switching on/off: Press the on/off
switch
once (Fig. G).
12 ]
[
4. Disconnect the power plug from the
socket-outlet if you do not use the product.
5. Winding up the power cord: Press the cable
winder button
(Fig. H).
7 ]
[
INFO:
Hold the power cord with one hand. Guide
the power cord while it is being wound up.
˜ Increasing/decreasing
suction power
Adjust the suction power with the secondary
o
air regulator
(Fig. I).
22 ]
[
17 ]
[
18 ]
[
16 ]
[
out of the housing, at
9 ]
[
GB/IE/NI
11
Advertenties
Inhoudsopgave
Probleemoplossen
