Before Use; Dust/Chip Extraction; Using Attachments; Use - Parkside Pdsb 10 A1 Vertaling Van De Originele Gebruiksaanwijzing
Perslucht-zuig-/ blaaspistool
Inhoudsopgave
Beschikbare talen
Beschikbare talen
Before use
Dust/chip extraction
CAUTION!
►
Please refer to the section entitled "Safety
instructions" .
►
Only use the appliance in the vacuum func-
tion when the dust bag is fitted . Otherwise,
particles can be accelerated towards the
user .
CAUTION!
►
First fit the angle piece
tion connection
to vacuum sharp-edged or metal swarf . Oth-
erwise, these could damage the dust bag
Dust extraction unit with dust bag:
♦
First, push the hose clip
the dust bag
.
♦
Push the opening of the dust bag
dust extraction connection
♦
Push the hose clip
connection
.
♦
Tighten the hose clip
clockwise .
NOTE
►
Empty the dust bag
regularly in order to guarantee optimal dust
extraction . To do this, open the zip on the
underside of the dust bag
Using attachments
You can attach a range of blow-out and vacuum
attachments to the appliance in order to reach
inaccessible locations .
♦
Push the flexible hose
After this, push the required nozzle
flexible hose
. Alternatively, you can also fit
the extension tube
its own .
■
12
│
GB │ IE
to the dust extrac-
if, for example, you want
over the opening on
onto the
.
over the dust extraction
by turning its wing nut
in good time and
.
over the opening
onto the
over the opening
Use
Connecting the compressed air supply
NOTE
►
The appliance may only be operated using
cleaned, condensate-free compressed air,
and the maximum operating pressure of 10
bar must not be exceeded on the appliance .
►
To ensure that you can regulate the air pres-
sure, the compressed air source should be
equipped with a (filter) pressure reducer .
♦
Connect the connector nipple
pressed air supply using a quick coupling .
Switching on and off
.
Switching the compressed air appliance on:
♦
press the operating lever
Switching the compressed air appliance off:
♦
Release the operating lever
♦
Disconnect the appliance from the compressed
air source after you finish work .
NOTE
►
First detach the hose from the compressed air
source (compressor) before disconnecting the
supply hose from the appliance . This prevents
the supply hose from thrashing about .
Function selection
You can use the appliance in two operating modes:
using the blow-out function:
♦
Turn the function selection wheel
▮ notch on the top of the appliance is pointing
to the ▲ BLOW marking on the function selec-
tion wheel
.
using the vacuum function:
♦
Turn the function selection wheel
▮ notch on the top of the appliance is pointing
on
to the ▲ VAC marking on the function selection
wheel
.
to the com-
completely down .
.
.
PDSB 10 A1
so that the
so that the
Hoofdstukken
Inhoudsopgave
