Toro 21770 Handleiding pagina 15
Verberg thumbnails
Zie ook voor 21770:
- Gebruikershandleiding (24 pagina's) ,
- Gebruikershandleiding (24 pagina's)
– Walk at a slower pace while mowing.
– Raise the cutting height on your machine.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full
swath with each pass.
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need
to make more than a single pass over the leaves.
•
If there are more than 13 cm (5 inches) of leaves
on the lawn, mow at a higher cutting height and
then again at the desired cutting height.
•
Slow down your mowing speed if the machine
does not cut the leaves finely enough.
All manuals and user guides at all-guides.com
After Operation
After Operation Safety
General Safety
•
•
•
Hauling Safety
•
•
Cleaning under the Machine
Service Interval: After each use
For best results, clean under the machine soon after
you have completed mowing.
13
Always shut off the machine, wait for all moving
parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Use care when loading or unloading the machine.
Secure the machine from rolling.
1.
Lower the machine to its lowest cutting-height
setting.
2.
Move the machine onto a paved level surface.
3.
With the engine running and the blade engaged,
spray a stream of water in front of the right, rear
wheel
(Figure
15).
Note:
The water will splash into the path of the
blade, cleaning out the clippings.
Figure 15
4.
When no more clippings come out, stop the
water and move the machine to a dry area.
5.
Run the engine for a few minutes to dry the
underside of the machine.
g002600
