Trixie TX9 Smart Gebruiksaanwijzing pagina 6

Beschikbare talen

2. In the app, select ADD DEVICE and then select SECURITY & VIDEO

SURVEILLANCE under SMART CAMERA (Wi-Fi).

3. On the following page, select AP MODE from the drop-down menu

in the upper right corner. Then tap NEXT.

4. On the following page, enter your Wi-Fi credentials. Tap NEXT.

5. Tap CONNECT NOW and select the hotspot of the feeder from the

list of available Wi-Fi networks: SmartLife_XXXX.

6. Then tap the BACK arrow until you land back in the Tuya app. The

pairing process should now start automatically. If the pairing process

does not start automatically, tap „Confirm Hot Spot Next" at the

very bottom of the app.

All manuals and user guides at all-guides.com

7. The app will start the pairing process and should connect to the

8. Tap FINISH to go to the feeder's user interface.

1. Reset the feeder by pressing and holding the SET button on the top

2. In the app, select ADD DEVICE. Under SECURITY & VIDEO SURVEIL-

3. On the following page, select EZ MODE from the drop-down menu

4. On the following page, enter your Wi-Fi credentials. Then tap on

5. The app starts the pairing process and should connect to the auto-

feeder after a short wait.

EZ Mode (2.4 GHz only)

of the unit for 5 seconds. An audible signal will sound and after a few

seconds the green indicator light should begin to flash slowly.

LANCE, locate the SMART CAMERA (Wi-Fi) field.

in the upper right-hand corner. Double check that the green indicator

light on the feeder is flashing. Confirm this and then tap NEXT.

NEXT.

matic feeder after a short wait.

Re-coupling

Please proceed as follows if you need to pair the feeder again - e.g.

after moving into a new home.

Open the Tuya App home page and long tap the Pet Feeder icon to

remove the device from the App. Note - all programmed feeding

times will be lost with this. Then wait about one minute until the

green LED on the front of the device starts flashing again. Then press

and hold the SET button for about 5 seconds to reset the machine.

You can then repeat the pairing process in AP or EZ mode.