Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ATTENTION!
Please observe the warnings and comments at the beginning of this chapter.
5. Put the water tank back in the holder.
6. Fill the water tank with two litres of water as indicated in Chapter 3.3.
7. Clean the water pipe as indicated in chapter 5.3.
8. Fill the water tank completely as indicated in chapter 3.3.
9. You can use the function for taking water normally again
5.2.2 Cleaning the ice dispenser
Ice in the ice dispenser can block the outlet. In this case, the ice dispenser must be cleaned or the blockage must be
removed.
1. Switch off the ice-making function as indicated in chapter 4.7.
2. Hold the ice dispenser with both hands and gently pull it free. Slowly remove the ice container from the door as
shown in the illustration.
3. Empty the contents of the ice dispenser.
4. Clean the ice dispenser if necessary.
ATTENTION!
Please observe the warnings and comments at the beginning of this chapter.
5. Put the ice dispenser back. Make sure the ice dispenser is securely in place. If it is not possible to secure the ice
dispenser in place, turn the cog at the back of the ice dispenser to the correct position and try again.
5.2.3 Clean the ice grid and the water pipe
Clean the ice grid if the ice-making function has not been used for a long time:
1. Empty the ice dispenser.
2. Wait until the ice dispenser is half full (about 24 hours).
3. Empty the ice dispenser again.
You can use the ice-making function normally again.
If the water tank has not been used for a long time, flush the water pipe:
1. Take two litres of water as described in chapter 4.4.
2. If necessary, follow the steps for adding water as described in chapter 3.3.
You can use the function for taking water normally again.
42
Ice outlet motor claw
Ice outlet channel
Advertenties
Hoofdstukken
Inhoudsopgave
