Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.7.1 Lights:
The lights can be switched on or off by pressing the "+"
button for 2 seconds. This is displayed by the relevant
symbol on the display (upper left corner).
6.7.2 Battery capacity:
This is displayed in 20% steps. As soon as the battery
display starts to flash, the battery must be charged
immediately.
6.7.3 Display mode:
By pressing the "On/Off" button you can now select
different display modes:
1. Display mode: "ODO" - Main
display: Speed
2. Display mode: "TRIP" - Main
display: Speed
3. Display mode: "TIME" - Speed
4. Display mode: "TRIP MAX" -
Main display: max. speed driven
5. Display mode: "TRIP AVG" –
Main display: average Speed
6. Display mode: "Instantaneous
power"- Main display: Speed
DANGER!
• Only carry out setting work when the device is
stationary and never when driving.
Rev. I | English
Additional
display: Total km
Additional
display: Daily km
Additional
display: Travel
time
Additional
display: Daily km
Additional
display: Daily km
Additional
display: Power in
Watt
21
6.7.4 fault code display:
when the electronics detect faults in the system, these
are displayed in the form of fault codes on the display.
Fault code
21
22
23
24
Motor Hall Signal Abnormality
25
26
30
Communication Abnormality
Faults can arise once sporadically. Each time the device
is restarted, the fault code is deleted. If the fault should
arise again, we recommend that you make a note of the
fault code and contact your dealer.
6.7.5
Settings:
You can open the settings menu in order to carry out
basic settings.
NOTE:
• These settings can only be carried out when stationary.
1. Deleting the odometer:
press the "+" and "-" buttons at the same time and keep
them pressed for 2 seconds. The "tC" menu opens.
"On/Off" button for 2 seconds in order to confirm the entry
and leave the menu.
or
Press the "On/Off" button briefly to confirm and toggle to
the next menu point.
The fault code always starts
with the letters "Err" and ends
with a two-digit number:
Definition
Current Abnormality
Throttle Abnormality
Motor Abnormality
Brake Abnormality
Low Voltage
The display shows "tC-n",
pressing the "+" button you
can toggle between "tC-n"
(do not zero daily
kilometres) and "tC-y"
(zero daily kilometres).
Select "tC-y" to zero the
odometer and press the
Empulse F55
Advertenties
Hoofdstukken
Inhoudsopgave
