Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
When the battery pack 3 is fully charged:
¾
Remove the battery pack from the charger
16. Then disconnect the power cord with
power plug 17 of the charger from the
socket.
˜ Connecting/removing the
dust extractor
m
WARNING! FIRE HAZARD!
Using power tools with a dust extraction
u
element which can be connected to a
vacuum cleaner poses a fire hazard!
Unfavourable conditions, e.g. sparking,
sanding metal or metal pieces in wood,
wood dust inside the vacuum bag can
ignite. This can particularly occur if the
wood dust is mixed with paint particles or
other chemicals and the ground product
is hot after long work periods. Therefore
avoid the sanding material and the
product overheating. Always empty the
vacuum bag in the vacuum cleaner before
taking breaks.
Always use a dust extractor.
u
Ensure the work area is well ventilated.
u
Observe your country's applicable rules
u
for the materials you are working on.
NOTE
When connecting or removing the dust
u
extractor 8 , no accessory tool may be
mounted.
34 GB/IE
(Fig. E)
Pull the locking cap 6 on its side grips.
¾
Place the dust extractor 8 on the product.
Make sure that the connection ring 5 is
positioned in the groove 9 . Release the
locking cap. The dust extractor should be
freely movable in the groove.
Push the hose of a proper vacuum cleaner
¾
(e.g. a workshop vacuum cleaner) onto the
adaptor 7 .
Removing the dust extractor 8 : Proceed in
¾
reverse order.
˜ Selecting an accessory tool
NOTE
The following accessory tools constitute
u
the most common types. If desired, consult
specialist retailers about further accessory
tools.
Plunge saw blade
Materials:
¾
¾
¾
¾
Use:
¾
¾
¾
Example:
¾
(Fig. F, a)
Wood
Plastic
Plaster
other soft materials
Cut-off cuts
Plunge cuts
Sawing close to the
edge, including in hard
to reach areas
Cutting notches in light
construction walls
Advertenties
Hoofdstukken
Inhoudsopgave
