Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Inserting open end accessory tools: Place
¾
the accessory tool into the accessory tool
holder 11.
Inserting close end accessory tools:
Additionally, remove the clamping nut 10.
Reattach the clamping nut after inserting the
accessory tool.
NOTE
You can attach the accessory tools into
u
the accessory tool holder 11 in any lock-in
position (Fig. H).
Tightening the accessory tool
(Fig. G)
Push the tool release lever 1 all the way
¾
down.
Removing the accessory tool
(Fig. G)
Fold the insert tool release lever 1 all the
¾
way upwards (180°).
Removing open end accessory tools: Pull
¾
the accessory tool out of the accessory tool
holder 11.
Removing close end accessory tools:
Additionally, remove the clamping nut 10 to
remove such accessory tools. Reattach the
clamping nut after pulling out the accessory
tool.
After removing the accessory tool: Push the
¾
tool release lever 1 all the way down.
˜ Setting the oscillation speed
Use the oscillation speed adjustment wheel
¾
4 to set the oscillation speed (Fig. J).
Setting 1: Low oscillation speed
Setting 6: High oscillation speed
36 GB/IE
NOTE
The oscillation speed required varies by
u
material and working conditions and can
be determined with tests.
The oscillation speed can also be changed
u
during operation.
˜ Switching on and off
m
CAUTION! RISK OF INJURY!
Always wear protective gloves when
handling or working with the product.
m
CAUTION! RISK OF INJURY!
Always hold the product with both hands
u
while working (Fig. I).
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation.
m
CAUTION! HEALTH RISK!
Never work on materials containing
u
asbestos. Asbestos is considered
carcinogenic.
(Fig. K)
Switching on: Slide the on/off switch 2
¾
forward (ON).
Switching off: Slide the on/off switch 2
¾
back (OFF).
Advertenties
Hoofdstukken
Inhoudsopgave
