Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Trial run
NOTE
Always carry out a no-load trial run before
u
starting work and after every accessory
tool replacement.
The trial run is to make sure the accessory
tools are correctly locked in place and will
not became loose during operation.
˜ Working instructions
Working principle:
The oscillating motor allows the accessory
¾
tool to oscillate back and forth 8000 to
20000 times per minute. This allows for
precision in the tightest of spaces.
Sawing/cutting:
Only use undamaged saw blades free from
¾
defects. Bent, dull or otherwise saw blades
can break.
Observe the law and the recommendations
¾
of the material manufacturers when cutting
light construction materials.
Only soft materials such as softwood,
¾
gypsum plasterboard etc. may be processed
using plunge cutting!
Sanding:
Apply even pressure to extend the life of the
¾
sanding sheets.
˜ Cleaning and care
m
WARNING!
Always switch the product off, remove
the battery pack 3 and let the
product cool down before performing
inspection, maintenance and cleaning
work!
˜ Cleaning
Never allow fluids to get into the product.
¾
The product must always be kept clean, dry
¾
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
¾
safe use and prolong the life of the product.
Clean the product with a dry cloth. Use a
¾
soft brush for areas that are hard to reach.
In particular clean the air vents after every
¾
use with a cloth and soft brush.
The vents must always be clear.
¾
NOTE
Do not use chemical, alkaline, abrasive
u
or other aggressive detergents or
disinfectants to clean this product as they
might be harmful to its surfaces.
˜ Maintenance
The product is maintenance-free.
¾
Before and after each use, check the product
¾
and accessories (e.g. accessory tools) for
wear and damage. If required, exchange
them for new ones as described in this
instruction manual. Observe the technical
requirements (see "Technical data").
Check covers and safety devices for
¾
damages and correct installation. Replace as
necessary.
GB/IE
37
Advertenties
Hoofdstukken
Inhoudsopgave
