Table 28. System setup options—Display menu (continued)
Display
Table 29. System setup options—Connection menu
Connection
Network Controller Configuration
Integrated NIC
Wireless Device Enable
WLAN
Bluetooth®
Enable UEFI Network Stack
Enable UEFI Network Stack
HTTP(s) Boot Feature
HTTP(s) Boot
HTTP(s) Boot Modes
Table 30. System setup options—Power menu
Power
USB Wake Support
Enable USB Wake Support
AC Behavior
AC Recovery
Active State Power Management
ASPM
Block Sleep
Block Sleep
Deep Sleep Control
84
BIOS-instellingen
Default: OFF
Controls the onboard LAN controller.
By default, Enable with PXE is selected.
Enables or disables the internal WLAN device.
Default: ON
Enables or disables the internal Bluetooth® device.
Default: ON
Enable or disable UEFI Network Stack.
Default: ON
Enables or disables HTTP(s) Boot Feature.
Default: ON
Configure the HTTP(s) Boot Mode. Auto Mode will extract Boot URL from the
Dynamic Host Configuration Protocol (DHCP). Manual mode reads user-provided
Boot URL.
By default, Auto Mode is selected.
Enables USB devices like a mouse or keyboard to wake the system from Standby,
Hibernation, or Power Off state.
Default: ON
Configures the system response when power is restored after an unexpected loss of
power.
Default: Power OFF is selected. The system stays off after AC power is restored.
Configures the Active State Power Management (ASPM) level.
Default: Auto. There is handshaking between the device and PCI Express hub to
determine the best ASPM mode supported by the device.
Blocks the computer from entering Sleep (S3) mode in the operating system.
Default: OFF