Parkside PMSHM2 A3 Bedienings- En Veiligheidsinstructies pagina 20
Verberg thumbnails
Zie ook voor PMSHM2 A3:
- Bedienings- en veiligheidsinstructies (75 pagina's) ,
- Bedienings- en veiligheidsinstructies (106 pagina's) ,
- Bedienings- en veiligheidsinstructies (181 pagina's)
Beschikbare talen
Beschikbare talen
Remove the used batteries.
Insert 2 LR03/AAA batteries. Observe the correct
polarity.
Insert the batteries in the battery compartment
7
and close the battery compartment cover
again,
6
so that it audibly latches into place.
Note: No button should be pressed while
inserting the batteries.
Start-up
Before you take a measurement
Ensure that both measuring pins
touch the
2
surface of the material at the same time.
Increase the pressure on the measuring pins
for
2
rough surfaces if necessary.
For delicate surfaces complete the measurement
on a section that is not in the visible area.
Note: The measuring pins
are sharp and may
2
dent or damage the surface.
20
GB/IE/NI
