AEG LF6284M Gebruiksaanwijzing pagina 41
Beschikbare talen
Beschikbare talen
A correct adjustment of the appliance
level prevents the vibration, noise and
the movement of the appliance when in
operation.
When the appliance is installed on a
plinth or a tumble dryer is stacked on the
washing machine, use the accessories
described in chapter 'Accessories'. Read
carefully the instructions supplied with
the appliance and with the accessory.
5.3 The inlet hose
1. Connect the water inlet hose to the back
of the appliance if needed. Usually, it is
already installed at the factory.
20º
20º
2. Position it toward left or right depending
on the position of the tap. Make sure that
the inlet hose is not in vertical position.
3. If necessary, loose the ring nut to set it in
the correct position
45º
45º
4. Connect the water inlet hose to the cold
water tap with 3/4" thread.
Some model can contain inlet hose with
water stop device. It prevents any leaks in the
hose because of its natural ageing. The
sector in the window shows this fault A. If this
occurs, close the water tap and contact the
authorized service center for information to
replace the hose.
3/4"
3/4"
A
WARNING!
The inlet water shall not exceed 25 °C.
CAUTION!
Make sure that there are no leaks from
the couplings.
Do not use an extension hose if the inlet
hose is too short. Contact the service
centre for information on inlet hose
replacement.
5.4 Water drainage
The drain hose should be positioned at a
height of not less than 60 cm and not more
than 100 cm from the floor.
You can extend the drain hose to
maximum 400 cm. Contact the
authorized service centre to buy the other
drain hose and the extension.
A
A
ENGLISH
41
