AEG LF6284M Gebruiksaanwijzing pagina 52
Beschikbare talen
Beschikbare talen
4. To use liquid detergent, turn the flap
down.
With the flap in the position DOWN:
• Do not use gelatinous or thick
liquid detergents.
• Do not put more liquid detergent
than the limit shown on the flap.
• Do not set the prewash phase.
• Do not set the delay start function.
5. Measure out the detergent and the fabric
conditioner.
6. Carefully close the detergent dispenser.
Make sure that the flap does not cause a
blockage when you close the drawer.
10.5 Setting a programme
1. Turn the programme dial to select the
desired washing programme. The related
programme indicator comes on.
The indicator of the Start/Pauze button
flashes.
The display shows an indicative programme
duration.
2. To change the temperature and/or the
spin speed, touch the related buttons.
52
ENGLISH
3. If desired, set one or more options by
touching the related buttons. The related
indicators come on in the display and the
given information changes accordingly.
In case a selection is not possible, no
indicator comes on and an acoustic
signal sounds.
10.6 Additional information about
daily use
The ProSense load detection
The appliance detects the load in the first 30
seconds, during detection the indicator
flashes. The indicator stop flashing at the end
of load detection.In case of drum overload,
the indicator
It is possible to pause the appliance and
remove the exceeding garments. If the
laundry amount will not be reduced, the
washing programme starts anyway. About 20
minutes after the programme start, the
programme duration could be adjusted again
depending on the capacity of water
absorption of the fabrics. The ProSense
System is not available in programmes with
short cycles.
Starting a programme
Touch the Start/Pauze button to start the
programme. The related indicator stops
flashing and stays on. The programme starts,
the door is locked. The display shows the
indicator
.
Starting a programme with delay start
1. Touch the Startuitstel button repeatedly
until the display shows the desired delay
time.
2. Touch the Start/Pauze button. The
appliance door locks and starts the
countdown of the delay start. When the
countdown is completed, the programme
starts automatically.
Interrupting a programme and changing
the options.
1. When the programme is running, you can
change only some options. Touch the Start/
Pauze button.
is flashing in the display:
