Amazon Basics B0B5DHMN7W Handleiding pagina 6
Draagbare luchtcompressorpomp met digitale drukmeter
Beschikbare talen
Beschikbare talen
EN
5. Operation
5.1 Switching on/off
1. Turn on the vehicle engine.
2. Roll out the 12 V auxiliary cord and
plug (B).
3. Connect the 12 V auxiliary cord and
plug (B) to the vehicle's 12 V cigarette
lighter socket. The display lights up,
the product is in standby mode.
4. To switch off the product, disconnect
the 12 V auxiliary cord and plug (B)
from the vehicle's 12 V cigarette lighter
socket. The display goes off.
5. Turn off the vehicle engine.
5.2 Inflating without preset function
» The product can be operated without
preset function, suitable for inflating
balloons, inflatable swimming pools
and other similar items.
» To operate the product without a
preset, press the
set the pressure gauge to '0' before
inflating.
» When inflating vehicle/bicycle tires,
always follow the manufacturers
recommended tire pressure.
NOTICE
The product has an auto shut off
function. Once the pre-set pressure
is reached, the product shuts off
automatically.
5.3 Inflating a vehicle/bicycle tire
NOTICE
» If the pressure in the tire is higher
than the set pressure, the compressor
will not start. If this happens, loosen
the thread connector (T) to release air
from the tire until the pressure is lower
than the set pressure or increase the
set pressure higher than in the tire.
6
button (M) to
» The product records the last preset
pressure. If you preset the pressure
gauge to 45 PSI, the product records
the preset pressure at 45 PSI for the
next use.
» This product is equipped with an auto
shut-off digital pressure gauge. The
digital gauge can be used to monitor
air pressure when inflating desired
objects, and can automatically shut
off once preset desired pressure is
reached.
» To avoid over-inflation of tires, check
the recommended vehicle tire pressure
in the vehicles owner's manual. For
bicycle tires, check the tire markings.
1. Turn on the vehicle engine.
2. Roll out the 12 V auxiliary cord and
plug (B).
3. Connect the 12 V auxiliary cord and
plug (B) to the vehicle's 12 V cigarette
lighter socket. The display lights up,
the product is in standby mode (Fig. 1).
1
4. Disconnect the tire valve cap.
5. Pull out the hose (U), then screw the
thread connector (T) onto tire's valve
stem (Fig. 2).
2
T
B
U
