Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2. Turn the adjuster screws (A) until the adjustment nut
(B) is opposite the mark on the drive belt cover.
B
A
3. Use a combination wrench and tighten the 2 bolts
that hold the cutting head to the cutting arm.
Starter housing
WARNING: Always be careful and always
use eye protection when you replace the
recoil spring or the starter rope. There is
tension in the recoil spring when it is wound
in the starter housing. The recoil spring can
eject and cause injury.
To remove the starter housing
1. Loosen the 4 screws on the starter housing.
2. Remove the starter housing.
72
To replace a damaged starter rope
1. Pull out the starter rope approximately 30 cm (A).
A
C
2. Hold the starter rope pulley (B) with your thumb.
3. Put the starter rope in the notch (C) in the starter
pulley .
4. Put the starter rope around the metal sleeve.
B
988 - 001 - 21.10.2019
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
