Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Inspired by life
Maintenance
Maintenance
You can do minor maintenance on the NEOX
yourself.
Cleaning and disinfection
Cleaning the back cushions and seat cushions can be
done by washing them according to the washing in-
structions on the product. The frame, push handles and
armrests can be cleaned with a damp cloth, water and
commercially available, non-abrasive detergent with a
pH between 5 and 9.
Disinfection can be done with 70% disinfectant. Allow
to air dry.
Note:
•
Never use abrasive and/or harsh detergents
or solvents, including thinner, dry cleaning
fluid such as thinner, benzene, and the like.
•
Do not use a pressure washer to clean the
wheelchair.
Please note:
•
Tightening the screws with excessive force
may damage the wheelchair..
Pneumatic tyres (option)
Check the tire pressure and the condition of the tires
(for aging) regularly. In order to drive the wheelchair
comfortably, i.e. with the lowest possible rolling and tur-
ning resistance, it is important that the tires are properly
inflated. When the tire pressure is low, the wheelchair
drives and maneuvers more heavily. To inflate the tires,
use a valve nipple (e.g. a bicycle pump). The maximum
tire pressure is indicated on the tires. Life & Mobility
recommends a maximum tire pressure of 6 bar. In case
of a flat tire, replace the tire.
Warning:
•
Under-inflated tyres have a negative impact
on braking power and driving characteristics.
EN38
Monthly
Check the functioning and/or damage/signs of
wear of the following parts on a monthly basis and
replace them if necessary (replace only with original
Life & Mobility spare parts):
•
Brake
•
Tyres (tread and condition of the tyre)
•
Seat, backrest, seat mat
•
Front wheel, rear wheel and its bearings
Major maintenance (annual)
Your dealer will be happy to carry out the major
maintenance of the wheelchair for you. This way
you can be sure that you are making optimal use of
your wheelchair. You can also contact your dealer
for the replacement of parts.
Dealer Servicing
During a service, the following points should be
checked:
•
During a service, the following points should be
checked:
•
Check parts for breakages. If a break is found,
the part must be replaced.
•
Check parts for rust. If necessary, touch up with
metal paint or replace.
•
Check moving parts for smooth movement. If
backlash adversely affects operation, modify or
replace parts.
•
Check bolted connections for tightening torque
and, if necessary, apply the overview below;
(unless otherwise stated in the manual or
instructional videos)
- M5 screws -> 6 Nm
- M6 screws -> 10 Nm
- M8, M10 and M12 screws -> 25 Nm
EN39
Advertenties
Hoofdstukken
Inhoudsopgave
