Advertenties
Beschikbare talen
Beschikbare talen
Display
Illustrate
E5
The mower is lifted up
E6
Rollover sensor has been
triggered
E7
Tilt sensors has been trig-
gered
E8
Charging docking unsuc-
cessful
E9
Trapped
E12
Battery error
E13
Charging error
E14
Cutting area is out of limit – Turn mower off.
BP
Battery pack temperature
protection
EE
Error unknown
Signal interference
LOCK
Continuously entering
wrong passwords
Action
– Turn mower off.
– Take mower to an area in your lawn free of obstacles.
– Turn mower on. Press [START] then [OK].
– If the error message is still displayed; turn power off;
turn mower upside-down. Check if there has some-
thing preventing the front wheels axle sliding.
– Remove any obstruction, turn mower upright, turn
power on. Press [START] then [OK].
– Turn mower upright. Press [START] then [OK].
– Turn mower off.
– Take mower to a flat ground in your lawn.
– Turn mower on. Press [START] then [OK].
– Check the Boundary wire on each side of the charg-
ing base should be straight for 1 m without corners or
obstacles to ensure proper docking.
– The charging station must be positioned on relatively
level ground. it must not be positioned on an inclined
surface or anywhere that makes its plate bend.
– Manually dock mower in the charging base for charg-
ing. After mower is fully charged, Press [START]
then [OK].
– Place mower to an area free of obstacles.
– If error persists, please contact after-sales service
– Please contact after-sales service to change battery
– Check if the charging head/pole is clean
– If the error persists, please contact after-sales ser-
vice to change charger
– Rearrange the boundary lines,reduce the cut area to
the declared range.
– Turn mower on. Press [START] then [OK].
– Or switch to a larger model.
– Check the battery temperature. the temperature is
too high, wait until the temperature has cooled down.
if the temperature is too low, wait untill the tempera-
ture >5 centigrade, Press [START] then [OK].
– If the error message is still displayed, replace a new
battery. Restart mower. Press [START] then [OK].
– If the error repeatedly occurs, contact a service
agent for help.
– Restart mower. Press [START] then [OK]. If the
error message is still displayed, contact a service
agent for help.
► Avoid signal interference – p. 52
– Please keep the mower on and wait for 10 minutes.
– After 10 minutes you can enter your password again.
– If you forgot your password, please contact after-
sales service.
GB
57
Advertenties
Hoofdstukken
